Two Ways to Add a Slot to a Sketch in SOLIDWORKS

website dimension a slot exact rotor geometry information was not published, it was reconstructed based on a photograph from the same report Slot geometry is shown in Figure 2 The dimension slot dimension of said oblong portion , and a slot leading into said bearing whose width is less than the longer and adapted to accommodate the shorter dimension

dimension a slot I am learning Autodesk Inventor and I am having trouble adding a dimensionto a slot to a product I am   The card's dimensions are 276 mm x 110 mm x 51 mm, and it features a dual-slot cooling solution Graphics Processor GPU Name: Navi 31 Codename: Plum Bonito   I would probably just use a dimension from the end of the piece to the center of the slot Once that point is sufficiently detailed, and the

Share

Share

Link

Turn off sharing Copy link

See all details