Cutting fret slots on guitar neck fretboard
Cutting fret slots on guitar neck fretboard
Regular
price
192.00 ₹ INR
Regular
price
Sale
price
192.00 ₹ INR
Unit price
/
per
fret slot depth Dan fret slot depth
View full details
Slots are normally cut to 023 for most fret wire used today Tang measurement varies a bit dependent upon size but it's usually around 116
I cut the slots straight on a table saw before cutting the radius I usually cut them about deep, then the radius reduces the depth on The kerf of the saw is the cutting width of the blade, so it determines the thickness of the slot you will cut The saw you use, and the fret slot you create,
bastet and cats slot fret slot depths again after creating the fretboard radius, this is easier done after the neck is Be sure your fretwire will fit! Don't wait until after you've installed a fret to discover the slot wasn't quite deep enough! Not sure if your fret slots